This is called the R.A. axis. Later in the procedure, you will also unlock the Declination or Dec lock ( 27, Fig. 2b and Fig. 9a ). When unlocked, the telescope pivots more or less vertically on the mount.

Please check your inbox, and if you cant find it, check your spam folder to make sure it didnt end up there.

If you follow all the Lessons in this section, you will become familiar with the basic operation of your telescope and the Starfinder handbox by the end of Part One.

Instruction For Meade 4501 How To Take A

How to observe using Starfinder and how to take a Guided Tour of the night sky.

The bolded numbers in parentheses on this page refer to the photos on page 4.

The Declination (Dec) electronic motor drive ( 13 ) has a connector for the Starfinder handbox, marked HBX.

The accessories are located within compartments custom-cut into the styrofoam block inserts.

Refer to Figures 1, 2a, 2b, and 2c for images of the parts and the overall assembly of the 4504 telescope.

For a listing of parts that are included in the giftbox, see pages 4 and 5.

When removing the tripod from the giftbox, hold the assembly parallel (horizontal) to the ground or the inner tripod leg extensions will slide out as they are not locked in place.

The three tripod lock knobs ( 7, Fig.

To install, thread each tripod lock knob into the threaded hole located at the right side of each of the three gray-colored castings at the bottom of each tripod leg.

See Fig. 3, and 29, Fig.

Tighten the tripod lock knob to a firm feel only to avoid damage to the tripod caused by overtightening.

Instruction For Meade 4501 Free When The

Slide the cardboard sheath upward to allow it to come free when the tripod legs are spread out during the next step.

Spread the tripod legs as far as they will open, so that the leg braces ( 28, Fig.

Should one of the leg braces slip out of the center triangle fastener, reposition the brace and slide it back into the triangle fastener.

If the pin does not move, slightly unscrew the counterweight lock knob ( Fig.

Holding the counterweight ( 8, Fig.

Once firmly attached, loosen the counterweight lock knob, slide the counterweight to the midpoint of the counterweight shaft, and re-tighten the lock knob firmly in place ( Fig.

Make sure that this safety washerknob always remains in place.

Remove the cradle ring lock knobs ( 20, Fig.

It does not matter which way you orient the holder lengthwise.

Then center the tube by adjusting the thumbscrews ( 7, Fig.

H 25mm eyepiece ( Fig.

The following lesson demonstrates how to balance your telescope.

To balance the telescope, you will unlock the Right Ascension or R.A.

Fig. 2b and Fig. 9a ).

When this axis is unlocked, the telescope pivots more or less horizontally on the mount.

This is called the R.A.

Later in the procedure, you will also unlock the Declination or Dec lock ( 27, Fig.

Fig. 9a ). When unlocked, the telescope pivots more or less vertically on the mount.

Instruction Manual For Meade 4501